-40%
12" x 10 Gauge Sheet Metal Roller Slip Roll rolling metalworking brass steel
$ 158.4
- Description
- Size Guide
Description
Item description
This slip roller enables you to roll sheet metal, copper, brass, or other ductile materials into tubes, rolls, or curved surfaces. Mass produced rollers aren’t designed to withstand consistent use. If just
a
single p
a
rt breaks you’ll have to replace the whole unit. M
ade of solid steel, this unit is built to last.
Your hardware store stocks 3/8" bolts for easy replacement in case of repair.
Able to bend up to:
1”
wide of 1/8” thick
Cold Rolled steel bar / plate
1.75” wide of 12 gauge (.105) Cold Rolled steel bar / plate
3.5”
wide of 14 gauge (.075) Cold Rolled steel bar / plate
6”
wide of 16 gauge (.060) Cold Rolled steel bar / plate
9”
wide of 18 gauge (.048) Cold Rolled steel bar / plate
12”
wide of 20 gauge (.036) Cold Rolled steel bar / plate
Aluminum and brass capacities are about 1.5-2 times wider, depending on specific material properties. Copper capacities are 2-3 times wider. Hot Rolled steel capacities may be 1.25 times wider.
Specific
ations
Mounting Style: Bolt down
Roller Diameters: 1.25 inches
Minimum rolling diameter: 2.5 inches
> As of 2021, the ends are precision laser cut and the base is made stronger. It will look better and be stronger than the side pieces shown in some pictures. The rollers are still 1.25" solid steel round bar.
>
The hand crank set
(optional, not recommended, sold separately on ebay) includes two handles, one for each side. Both sides need to be installed during use.
We have found that the easiest
operation is with a hex bolt on which you place a standard 9/16 ratchet, breaker bar, or box-end wrench.
> Slip-rolling is a slow process and usually requires 12-20 passes through the rollers, with small, incremental tightening on the adjuster block to achieve a smooth roll. Overloading a slip roller is very easy, however, can shorten the life of the unit. Exercise
additional care
when rolling hardened or stainless steels
as
you may damage the surface of the rollers.
> Disassembly and reassembly is easy. Simply lower the adjuster bolt to rele
ase
pressure from the system. Then unscrew the two end bolts from the top roller
and remove the workpiece.
> This product is generally in stock and will ship in 1-2 days, Fedex Ground.
Cammeck Equipment is a family owned, Washington based, manufacturing company. Thanks for supporting local businesses by buying our products!
.
NOTE:
Please use caution while operating, slip rollers are dangerous and can crush fingers or other objects.